Wall Mounting - Style 10-10S-10D-10Sd - Bodet Style 5 Notice D'installation Et De Mise En Service

2.2 Wall mounting – Style 10-10S-10D-10SD
The visuals below refer to the Style 10 clock. However, the installation process shown also applies
to Styles 10S, 10D and10SD. Refer to the Technical specifications on page 26 for clock dimensions.
1) Fix the wall bracket to the wall using the four Ø4 mm dowel screws supplied.
2) Insert the RJ45 network cable:
• From above: cut through the casing
at the top, between the two labels u.
• From behind: dedicated area v.
3) Clip the electronic board into the wall
bracket. Insert the lower part of the electronic
board into the back of the wall bracket , then
push the upper part of the board into the
back of the bracket until it clicks w.
4) Connect the RJ45 network cable to the
electronic board connector x.
Power is supplied by the PoE Ethernet
network.
5) Connect the network cable to the
electronic board using a plastic tie (mounting
hole provided in the electronic board).
6) Connect the ribbon from the LED modules
(clock casing) to the electronic board y.
ATTENTION: To avoid damaging the
product, please, watch for the orientation
of the flat cable connector. For that
purpose the connector is keyed (A) and
marked (B).
7) Attach the clock to the wall bracket by
inserting the upper part of the clock into the
back of the bracket in the slots provided,
then press the clock in until it clicks.
Secure the clock to the bracket at the bottom,
using the mounting screw provided.
Ensure that the cables are not trapped
during this operation.
8) The clock may be subsequently detached from the bracket by lifting the lower part of the clock
outwards, then removing the upper part.
9) Remove the protective film from the front and clean the clock using an anti-static cloth.
Important : about double face installation on support bracket, refer to the manual supports,
ref.: 607847 (included with the bracket).
u
w
y
A
A
B
B
EN
v
Back view
w
x
Wall bracket +
electronic board
Right side
cutaway view
7