What To Do If - Bodet Style 5 Notice D'installation Et De Mise En Service

XII

– What to do if...

What to do if...
There is no synchronisation
after installation.
The NTP slave is not set to
the correct time.
There is no DHCP server on
the network.
One of the Style clocks
does not switch on or
repeatedly reboots.
32
1) The signal type sent by the master clock is the same as the
clock's signal type (IE NTP).
2) The IP address of the server is the same as the clock's web
interface and the receiver.
3) The NTP server is on the same network as the slave
(IP addresses, subnet mask and gateways).
1) The time zone selected on the web server is correct.
1) The default network configuration on the clock is as follows:
– IP: 172.17.30.110
– MASK: 255.255.0.0
– GATEWAY: 0.0.0.0
– DNS: 0.0.0.0
1) The maximum power from the PoE switch is sufficient to supply
all of the clocks connected to the switch.
2) Cable length is less than 100 metres (refer to the network wiring
standards).
3) All switch outputs are PoE-compatible..
Check that...
EN