What To Do If; Check - Bodet Cristalys 7 Instructions De Mise En Service Et D'utilisation

-9s99 and +9s99 per 10ms step (#0.12 ppm). The addition of this daily offset to the time
base will be spread over 24 hours.
7. Press [SELECT] again to exit the technician menu and return to the
time display.
Reminder : At any time, holding down the [SELECT] button, then
pressing the [+] button quickly, goes to normal display mode and exits
the configuration menu.
If no buttons are pressed for 10 minutes, the clock returns automatically to time display mode.
VIII - WHAT TO DO IF...?

WHAT TO DO IF...?

The clock displays
The clock does not display the day
of the week but a number.
The clock display does not go
beyond 12 hrs.
The time synchronisation of the
clock is correct, but the time change
has not taken place, the date or the
time is not correct.
The display has disappeared, only
the 2 dots are flashing.
34

...CHECK.

The clock detects the "low battery" threshold
.
battery appears as a fixed display for 5 days. After
this period, it flashes until the display disappears
completely (batteries have run out). Replace the
batteries. Resetting of the time and date is,
automatic for radio synchronised or Irig-B / AFNOR
clocks, manual for independent and receiver clocks.
Dust on the battery contact terminals (+ and -) can
disrupt the power supply to the clock. Clean these
contact terminals with a soft dry cloth, if necessary.
The clock is programmed in week number or day
number display mode (reread the note on page 27,
§ 5 ).
The clock is programmed in 12 hr instead of 24 hr
mode (reread the note on page 26, § 2 ).
Check in time change mode that the clock is
correctly programmed (reread the note on page
27, § 6).
You are in "Eco" mode between 11pm and 6am.
... CHECK.
, the pictogram representing an empty