Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VIII - WHAT TO DO IF...?
WHAT TO DO IF...?
The clock does not display the day of
the week but a number.
The clock display does not go
beyond 12 hrs.
The time synchronisation of the
clock is correct, but the time change
has not taken place, the date or the
time is not correct.
The display has disappeared, only
the 2 dots are flashing.
No display of time, only fixed colon
mark.
The time display is correct and the
two dots are fixed.
no synchronisation after the
installation.
NTP receiver not at the correct time
after a deliberate time change on the
master clock.
The display is completely blank.
The time synchronisation of the
clock is correct (the radio pictogram
is on fixed display), but the time
change has not taken place, the date
or the time is not correct.
...CHECK.
The clock is programmed in week number or day
number display mode (reread the note on page 24,
§ 5 ).
The clock is programmed in 12 hr instead of 24 hr
mode (reread the note on page 24, § 2 ).
Check in time change mode that the clock is
correctly programmed (reread the note on page 25,
§ 6).
You are in "Eco" mode between 11pm and 6am.
The NTP clock has not been synchronised for more
than 24 hours: check that the transmitter is
functioning correctly.
The NTP clock is configured in NTPi mode, has not
been synchronised for more than 24 hours and is
functioning autonomously: check that the transmitter
is functioning correctly.
Check that the master clock is configured with the
same Multicast address (see manual, page 29).
1) the time setting is not instantaneous (three
coherent time messages must be received before
the time change is taken into account).
2) change the time of the clock manually to cause
an immediate NTP synchronisation search.
Lack of mains, restore it.
Check in time change mode that the clock is
correctly programmed (reread the note on page 25,
§ 6).
... CHECK.
31
Publicité
Table des Matières
