Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
X
– What to do if...
What to do if...
There is no synchronisation after
installation.
The NTP slave is not set to the
correct time.
There is no DHCP server on the
network.
One of the Style clocks does not
switch on or repeatedly reboots.
22
1) The signal type sent by the master clock is the same as the clock's signal
type.
2) The NTP server is on the same network as the slave (IP addresses, subnet
mask and gateways).
1) The time zone selected on the web server is correct.
1) The default network configuration on the clock is as follows:
– IP: 172.17.30.110
– MASK: 255.255.0.0
– GATEWAY: 0.0.0.0
– DNS: 0.0.0.0
1) The maximum power from the PoE switch is sufficient to supply all of the
clocks connected to the switch.
2) Cable length is less than 100 metres (refer to the network wiring standards).
3) All switch outputs are PoE-compatible..
Check that...
EN
Publicité
Table des Matières
