18
Enter centrifugation parameters
Parameters can be input via the operating unit (key position "0") or via the interface (key position "LOCK 2").
The functions of the various key positions are described in the "Key-operated switch" chapter.
If no key is pressed for 8 seconds long after the selection or during the input of parameters, the previous
values will be shown in the display. The input of parameter then has to be executed again.
If several parameters are input, the
accept all changes.
If parameters are changed, the program place number is displayed in parentheses (). This means that the
centrifugation data in the display no longer corresponds to the centrifugation data from the program place that
has been saved.
You can no discontinue entering parameters at any time by pressing the key
adjustments are not saved.
18.1
Running time
In order to set continual running, the minutes, seconds and hours have to be set to zero.
Continual running is represented in the display by the following symbol, "∞".
•
Press the
key. The parameters t/hms is displayed. The minutes ( m) are shown in parentheses 〈〉, and can
TIME
be changed.
•
Use the adjusting knob
•
Press the
key. The seconds ( s ) are shown in parentheses 〈〉and can be changed.
TIME
•
Use the adjusting knob
•
Press the
key. The hours ( h ) are shown in parentheses 〈〉 and can be changed.
TIME
•
Use the adjusting knob
•
To apply the setting to the display, either press the
the centrifugation data are displayed.
18.2
Starting runtime timing
The start to runtime timing can only be set if the function, "Dual time mode" has been activated. See chapter
"Activate or deactivate function "Dual time mode". This function is activated ex works.
•
Press the
key as often as is required until Timing begins at start or Timing begins at speed is displayed.
TIME
•
Select the desired setting with the turning knob .
Timing begins at Start
Timing begins at Speed = The runtime only begins to count after the set speed is reached.
•
Press the
or
TIME
START
18.3
Speed (RPM)
•
Press the
key. The parameters RPM is displayed.
RPM
•
Use the adjusting knob
•
Press the
or
RPM
START
AB5680DEENFRIT
key must be pressed after setting the last parameter in order to
START
to set the value you want.
to set the value you want.
to set the value you want.
START
= The runtime begins to count immediately after the centrifugation run starts.
This is indicated on the display by the symbol , to the left next to the time.
keys to apply the setting to the display.
to set the value you want.
keys to apply the setting to the display
Rev. 12 / 04.2020
OPEN / STOP
key or press the
key as often as is required until
TIME
EN
. In this case the
71/179