Specifying Audio Settings; Switching The Input Jack Sensitivity; Adjusting The Balance Of Low To High Frequency Ranges; Global Eq - Boss eBand JS-10 Mode D'emploi

Specifying Audio Settings

Here's how to specify the settings related to the input and output
of audio .

Switching the INPUT Jack Sensitivity

Select the input sensitivity that matches the device connected to
the JS-10's INPUT 1 and INPUT 2 (GUITAR/MIC) jacks .
1.
Follow this sequence of steps: [MENU] button  "AUDIO
SETTING"  [ENTER] button  "INPUT"  [ENTER] button .
The INPUT screen appears .
GAIN
Set the input sensitivity .
GAIN Explanation
Select when a guitar is connected to INPUT jack .
Select when a mic is connected to INPUT jack .
MEMO
The Input Sensitivity icon displayed on the top screen changes
according to the GAIN settings .
Input Sensitivity Icon
* When setting the GAIN to mic, be sure to check that the effect
from the microphone category is selected beforehand .
* Howling (feedback) is produced if you set the GAIN to mic while
a guitar effect is selected .
* Also, if you switch from a factory default song, the guitar effect
may change automatically to the effect set in PATCH SYNC (p . 22)
and produce sudden howling (feedback) . If this is the case, set
the PATCH SYNC's SYNC SW setting to OFF so that the patch is
not allowed to switch .
Adjusting the Balance of Low to High
Frequency Ranges (Global EQ)
1.
2.
PAN
Set the pan effect
for the input sound
to INPUT jack .

Turning Off the JS-10 Speakers

1.
Here's how to apply the equalizer to the overall sound of the JS-10
and adjust its balance .
Follow this sequence of steps: [MENU] button  "AUDIO
SETTING"  [ENTER] button  "EQ"  [ENTER] button .
The GLOBAL EQ screen appears .
Apply the GAIN setting for each band .

GLOBAL EQ

Explanation
LOW GAIN Adjusts the low-end volume .
MID GAIN Adjusts the midrange volume .
HIGH GAIN
Adjusts the high-end volume .
MEMO
Press the [ENTER] button in the GLOBAL EQ screen to turn the
equalizer on and off .
You can output audio from the JS-10's LINE OUT jacks to an external
playback device (e .g ., component stereo system) . When doing so,
you may want to turn off the JS-10's internal speakers .
Follow this sequence of steps: [MENU] button  "AUDIO
SETTING"  [ENTER] button  "SPEAKER"  [ENTER]
button .
Apply the settings for SPEAKER SW .
SPEAKER SW Explanation
OFF No sound will be produced by the internal speakers .
ON
The sound will be produced by the internal speakers .
MEMO
The tone quality of sound output from the OUTPUT jack
changes based on the SPEAKER SW settings . This does not
indicate a malfunction .
Convenient Functions
23