Basic Operation; Turning The Power On; Turning The Power Off; Moving The Cursor - Boss eBand JS-10 Mode D'emploi

Masquer les pouces Voir aussi pour eBand JS-10:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 92

Basic Operation

This section introduces the basic operations for using the JS-10 .

Turning the Power On

Once everything is properly connected (p . 4), be sure to follow the
procedure below to turn on the power . If you turn on equipment in
the wrong order, you risk causing malfunction or equipment failure .
MEMO
• Before turning the unit on/off, always be sure to turn the volume
down . Even with the volume turned down, you might hear some
sound when switching the unit on/off . However, this is normal
and does not indicate a malfunction .
• With the factory settings, the JS-10 will automatically
be switched off 30 minutes after you stop playing or
operating the unit . If you don't want the unit to turn
off automatically, change the "AUTO OFF" setting to
"OFF" as described on p . 26 .
1.
Turn the [MASTER LEVEL] knob down to the minimum
level .
2.
Press the [POWER] button to turn the unit on .
The unit's display will be lit .
* This unit is equipped with a protection circuit . A brief interval (a
few seconds) after turning the unit on is required before it will
operate normally .
3.
Turn the [MASTER LEVEL] knob and adjust the volume .
Files included on the supplied SD card
The supplied SD card is inserted into the JS-10 prior to being shipped from the factory .
The following files are included on the SD card .
eBand Song List Editor
This PC software can rip songs from CDs to JS-10 and add names to eBand songs .
Connect the JS-10 with your PC to use this software . For details, refer to "Importing Songs from a PC to the JS-10 (eBand
Song List Editor)" (p . 13) .
USB driver
This PC driver (control software) is used for listening to your PC's sound on the JS-10 .
For details, refer to "Using the JS-10 as a USB Audio Interfaces" (p . 27) .
ROLAND folder
Files needed for the operation of the JS-10 are saved in this folder . Make sure not to change or delete the contents of this folder .
MEMO
For details about the memory configuration in JS-10 or the data that is saved, refer to "Memory Configuration in the JS-10" (p . 38) .

Turning the Power Off

1.
Turn the [MASTER LEVEL] knob down to the minimum
level .
2.
Press the [POWER] button .
The power turns off .

Moving the Cursor

There are multiple parameters (settings) and selections on the
screen .
Press the [
] [
] (Cursor) buttons to move the cursor .
The parameter value selected with the cursor will be highlighted .

Selecting an Item

To select a displayed item or icon, move the cursor to the item or
icon, and press the [ENTER] button .
This manual uses the following conventions to indicate the steps of
a procedure, such as pressing the [MENU] button in the Top screen,
selecting "SYSTEM, " and then pressing the [ENTER] button .
[MENU] button  "SYSTEM"  [ENTER] button
MEMO
Press the [EXIT] button several times until you return to the Top
screen .

Changing the Value

To change the parameter setting, move the cursor to the applicable
parameter value, then turn the Dial to change the value . The value
increases when the Dial is turned clockwise and decreases when it
is turned counterclockwise .
5

Publicité

Table des Matières
loading

Table des Matières