Specifying The Type Of Output (Stereo Or Mono/Dry); Using A Condenser Mic (Phantom Power); Cutting Unwanted Low Frequencies; Adjusting The Screen's Legibility (Contrast) - Boss Vocal Performer VE-20 Mode D'emploi

Convenient Functions
Specifying the type of output
(Stereo or Mono/Dry)
If you want the VE-20's sound to be output in stereo
or as mono/dry signals, make the following setting.
1.
Press the MENU button.
2.
Press cursor button (
Output.
3.
Turn the SOUND knob to select Stereo or
Mono/Dry.
Here, Stereo is selected.
To learn more about the parameters, refer to
"Output"(p. 19).
4.
Press the EXIT button to return to the Play
screen.
Using a condenser mic
(Phantom Power)
If you're using a condenser mic that requires
phantom power, turn phantom power on as
described below.
1.
Press the MENU button.
2.
Press cursor button (
Phantom Power.
3.
Turn the SOUND knob to select On.
4.
Press the EXIT button to return to the Play
screen.
Always turn the phantom power off when connecting any
device other than condenser microphones that require
phantom power. You risk causing damage if you mistakenly
supply phantom power to dynamic microphones, audio
playback devices, or other devices that don't require such
power. Be sure to check the specifications of any micro-
phone you intend to use by referring to the manual that
came with it. (This instrument's phantom power: 48 V DC, 10
mA Max)
16
) to select the
) to select the
Cutting unwanted low
frequencies
If you want to cut unwanted low-frequency content,
turn on the LowCut parameter.
1.
Press the MENU button.
2.
Press cursor button (
Cut.
3.
Turn the SOUND knob to select On.
4.
Press the EXIT button to return to the Play
screen.
Adjusting the screen's
legibility (Contrast)
1.
Press the MENU button.
2.
Press cursor button (
Contrast.
3.
Turn the SOUND knob to adjust the Contrast.
4.
Press the EXIT button to return to the Play
screen.
) to select the Low
) to select the