Removing The Carry Bag; Installing Shoulder Straps - Invacare Platinum Mobile Manuel D'utilisateur

5. Lay the concentrator and carry bag down with air intake
filter screen facing upward.
6. Push the concentrator into the carry bag until it is fully
seated against the top retainer.
7. Rotate the base of the carry bag onto the bottom of
the concentrator and fully zip up the bottom of the
carry bag.
8. Return the concentrator and carry bag to the upright
position.
9. Check that the cutouts in the top retainer are correctly
aligned with the oxygen outlet port and external power
input connector. If not aligned, remove the carry bag
and reinstall as described in steps 1–9.

3.4.2 Removing the Carry Bag

1. Ensure the concentrator is off and disconnected from
external power and cannula.
2. Lay the concentrator on a flat surface with the air intake
filter screen facing upward and fully unzip the base.
3. Rotate the base of the carry bag off the bottom of the
concentrator.
4. From the bottom, pull the concentrator out of the carry
bag. If needed, the top surface of the concentrator
can be pushed to help remove it from the bottom of
the carry bag.
5. Return the concentrator to the upright position.
6. Fully zip up the bottom of the carry bag.
1187376-C

3.4.3 Installing Shoulder Straps

The carry bag can be configured as a messenger bag
using one shoulder strap or as a back pack using
two shoulder straps.
Messenger Bag Configuration
1. Using a single shoulder strap A, attach a clip B from
each end of the strap to rings C at the top of the carry
bag D.
2. Adjust shoulder strap to desired length.
3. Slide pad Eon shoulder strap to the desired location.
Setup
31