Invacare® Platinum® Mobile
3 Setup
3.1 Unpacking
1. Check for any obvious damage to the carton or its
contents. If damage is evident, notify the carrier or
your local dealer.
2. Remove all loose packing from the carton.
3. Carefully remove all the components from the cartons.
The Invacare concentrator's packaging contains the
following items (as shown below) in addition to this
user manual. If any parts are missing, please contact
your equipment provider.
•
Concentrator (Model POC1–100C) with carry bag
(Model POC1–150) installed
•
Cannula (Westmed #0194)
•
Two shoulder straps (Part Number 1187483)
•
Battery (Model POC1–110)
•
AC power adapter (Part Number 1187452)
•
AC power cord (Part Number 1187454 for model
POC1–100C)
•
DC power cable (Model POC1–140)
Retain all containers and packing materials for
storage or return shipment.
3.2 Inspection
Inspect/examine exterior of the oxygen concentrator and
accessories for damage. Inspect all components. If damage
is found, DO NOT use concentrator. Contact your provider
for service and/or repair or for assistance with the setup
procedure and to report unexpected operation or events.
24
3.3 Powering the Oxygen Concentrator
WARNING!
Risk of Injury or Damage
To avoid injury and damage that will void the
warranty:
– Use only Invacare specified power supplies with
the oxygen concentrator.
– Prior to using the DC power cable, the
automobile (boat, motor home, etc.) engine
should be running in order to either operate or
charge the oxygen concentrator.
IMPORTANT
The concentrator will not turn on unless the
battery is charged.
– Connect AC power to the concentrator and
allow battery to fully charge prior to first use.
The oxygen concentrator allows the freedom to choose from
the following power sources to enable use both inside and
outside of the home:
•
Rechargeable battery(s)
•
AC power outlet
•
12 volt DC power cable
1187376-C