Carry Bag Setup; Installing The Carry Bag - Invacare Platinum Mobile Manuel D'utilisateur

Invacare® Platinum® Mobile
the oxygen concentrator to be operated and simultaneously
recharge the battery.
Complete the following steps to connect the DC power cable
to the concentrator:
1. Insert the DC power cable outlet connector F into the
external power input connector C of the concentrator.
2. Insert plug H into a DC outlet after the automobile
(boat, motor home, etc.) is running.

3.4 Carry Bag Setup

CAUTION!
Risk of Damage
– Improper installation of the concentrator into
the carry bag can cause a high temperature
alarm condition and result in the concentrator
shutting down.
– The carry bag is not designed to protect the
concentrator from excessive drops, impacts,
or abuse.
– To install or remove the carry bag the
concentrator must be off and disconnected
from external power and cannula.
Concentrator can be operated with or without
the carry bag. When out of the carry bag, the
concentrator is limited to stationary use. Refer to
Using the Carry Bag in Usage.
30

3.4.1 Installing the Carry Bag

1. Fully unzip the base of the carry bag.
2. Position the concentrator standing upright on a flat
surface and oriented with air intake opening A facing
you. Ensure the concentrator is off and disconnected
from external power and cannula.
3. Position the carry bag above the concentrator with the
air intake filter screen B facing you.
4. Hold the unzipped bottom of the carry bag open C,
and slide the carry bag down onto the concentrator
until the carry bag completely covers the concentrator.
1187376-C