Cleaning The Device And Accessories; Emptying The Dust Container - Cleanmaxx PC-U001 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

Cleaning the Device and Accessories

CAUTION!
Empty and clean the dust container, the cyclone insert and the HEPA fi lter regularly
to prevent the motor from overheating.
Keep the motor unit away from water or other liquids to avoid electric shocks. Make
sure that no liquid gets into the motor unit during cleaning.
The HEPA fi lter is neither machine-washable, dishwasher-safe nor suitable for tum-
ble drying!
Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These could damage the surfaces.
The HEPA fi lter may lose some of its colour over time. This is normal and does
not have any adverse effect on function.

Emptying the Dust Container

Cleaning the Dust Container, Cyclone Insert and HEPA Filter
The cyclone insert is located in the dust container. The HEPA fi lter sits on the cyclone
insert.
07517_de-en-fr-nl_A5_V1.indb 26
07517_de-en-fr-nl_A5_V1.indb 26
26
1. Press the
release button on the dust container handle
and remove the dust container.
2. Hold the dust container over an open dustbin. The dis-
tance between the dust container and the dustbin should
be as short as possible to ensure that the dust from the
dust container falls into the dustbin only and does not
spill into the environment.
3. Press the button to open the dust container. The bottom
of the dust container will open and the dirt will fall out.
4. Close the bottom of the dust container again. The fas-
tener must be heard to engage in place.
5. Plug the closed dust container into the motor unit until it
is heard to engage in the locking mechanism.
1. Remove the dust container from the device and empty it
(see the "Cleaning the Device and Accessories" chapter,
section "Emptying the Dust Container").
2. Turn the lid of the dust container as far as it will go in
an anticlockwise direction. When the line marked on the
edge of the lid is next to the
tainer, remove the lid.
symbol on the dust con-
29.04.2016 12:38:55
29.04.2016 12:38:55

Publicité

Table des Matières

Dépannage

loading

Ce manuel est également adapté pour:

Z 07517

Table des Matières