Cleaning And Storing The Device; Emptying The Dust Container - Cleanmaxx 00877 Mode D'emploi

• When the device is switched on, the charge status of the battery is indicated
by the two green battery charge status lamps (11). If both lamps are lit up, the
battery is full. If only the red operating lamp is lit up, the battery needs to be
charged up.
• If the suction power diminishes even though the battery is full, empty the dust
container (18).
• If the device is not going to be used for a lengthy period, take out the battery!
1. Select an accessory as required (see the "Device Overview" chapter – "Accesso-
ries") and attach it to the device (see the "Assembly" chapter).
2. Switch on the device. To do this, press the On / Off switch (12).
– If it is only pressed lightly, the device automatically switches off again after it is
released. This is suitable for brief operation.
– For longer operation, press the On / Off switch down fully. The device then remains
switched on even after you let go of the switch. To switch off the device, the On / Off
switch must be pressed again.
3. Guide the nozzle over the surface to be cleaned.
4. After vacuuming, switch off the device, then empty the dust container and clean it if
necessary (see the next "Cleaning and Storing the Device" chapter).

Cleaning and Storing the Device

NOTE!
■ Switch off the device before you clean it.
■ Keep the motor unit, the charging station, the turbo nozzle, the mains adapter and the
mains cable away from water or other liquids to prevent electric shocks.
■ Do not immerse the HEPA fi lter in water or rinse it under running water to prevent
damage to the fi lter. It is neither machine-washable, dishwasher-safe nor suitable for
tumble drying.
■ Accessories that are cleaned with water must be completely dry when they are in-
serted back into the device!
■ Do not use any sharp or abrasive cleaning agents or cleaning pads. These could
damage the surfaces.
The fi lter may lose some of its colour over time. This is normal and does not
have any adverse effect on function.

Emptying the Dust Container

closed
open
23
1. Remove the dust container (18) from the motor unit (14).
Turn it a little to do this. It is released from the motor unit
and can be removed.
2. Hold the dust container over an open dust container. The
distance from the dust container should be as small as
possible so that the dust does not spread in the surround-
ing air.
EN