Korg PA 900 Guide De L'utilisateur page 435

-Wet, -
Wet/Dry 1:99...Dry...99:1
, Wet
l
Src Off...Tempo
Amt –100...+100
i: Time Over? L, R
You can set the delay time up to 2,550msec. If the delay time
exceeds this limit, the error message "OVER!" appears in the dis-
play. Set the delay time parameters so that this message will not
appear. "Time Over?" is only a display parameter.
Balance between the wet and dry
signal
Table , "Dynamic Modulation
sources, " on page 357
Amount of modulation source
69: St.BPMAutoPanDly
(Stereo BPM Auto Panning Delay)
This stereo auto panning delay enables you to set the delay time
to match the song tempo.
Stereo In - Stereo Out
Left
High Damp Low Damp
Delay
Feedback
Delay
High Damp Low Damp
Right
Tempo
BPM
Base Note x Times
BPM
Base Note x Times
LFO: Tri / Sin LFO Shape
MIDI,
BPM 40.00...
300.00
a Time Over? L ---, OVER!
R ---, OVER!
L Delay Base
r...w
Note
b Times x1...x32
Feedback –100...+100
R Delay Base
r...w
Note
c Times x1...x32
Feedback –100...+100
High Damp [%] 0...100
d
Low Damp [%] 0...100
LFO Waveform Triangle, Sine
Shape –100...+100
e
LFO Phase –180...+180
Panning Freq
f 0.02...20.00
[Hz]
MIDI Sync Off, On
MIDI,
BPM 40.00...
300.00
g
Base Note r...w
Times x1...x32
Panning Depth 0...100
Src Off...Tempo
h
Amt –100...+100
Dry, 1:99...99:1,
Wet/Dry
Wet
i
Src Off...Tempo
Amt –100...+100
Page 421
FX Amt
Pan
Depth
Pan
FX Amt
LFO Phase
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Display the error message if the left
channel delay time exceeds the
upper limit
Display the error message if the
right channel delay time exceeds
the upper limit
Selects the type of notes to specify
the left channel delay time
Sets the number of notes to specify
the left channel delay time
Sets the feedback amount for the
left channel
Selects the type of notes to specify
the right channel delay time
Sets the number of notes to specify
the right channel delay time
Sets the feedback amount for the
right channel
Sets the damping amount in the
high range
Sets the damping amount in the low
range
Selects the LFO Waveform
Changes the curvature of the LFO
Waveform
Sets the LFO phase difference
between the left and right
Sets the panning speed
When this is on, the pan LFO speed
is set by BPM, Base Note, and Times,
instead of Frequency
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Selects the type of notes to specify
the delay time for the panning
speed
Sets the number of notes to specify
the delay time for the panning
speed
Sets the panning width
Selects the modulation source for
the panning width
Set the modulation amount of the
panning width
Balance between the wet and dry
signal
Table , "Dynamic Modulation
sources, " on page 357
Amount of modulation source