Setting Up; Filling Ground Coffee - Melitta cup-breakfast Mode D'emploi

9. Setting up

When the machine has been installed, connected and
prepared for operation according to the above instruc-
tions, you can now set it up (filling and programming)
for dispensing products:
a) Switching on
You can switch the machine on before filling, so that it
already starts heating up. To do this... !
turn the water tap on,
❍
! open the door, using the key and ...
" switch the mains supply on.
insert the spray protection plate (p.11). Very hot
❍
water is dispensed during the warming-up phase
GB
there is thus a danger of scalding!
b) Filling ground coffee
# After opening the machine door: open the
housing lid and ...
lift the cover of the ground coffee container.
➀
$ Now you can fill the ground coffee container
and then close everything again.
Caution do not mix up containers! The rear
➁
container is for ground coffee. This is clearly
indicated by the sticker in the lid.
c) Filling instant powder
% When the machine door is open: turn the powder
chute upwards and ...
& remove the instant product container by lifting
it slightly and pulling away from the machine.
Take the instant container cover off. Now you
➂
can fill in the instant powder (don´t press down!)
and immediately replace the cover. Please
ensure that the lip of the cover points forward.
eplace the instant product container in such a
❍
way that the pin at the front of the container
bottom ...
clicks firmly into the hole on the bottom of the
➃
instant product compartment. Only then is the
container correctly installed again.
% Before closing the machine door, don´t forget to
turn the powder chute down into the funnel
again.
Now close the door and observe the display
message.
➁
➀
$
"
12
#
&
%
➂
➃