Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
e)
Daily: cleaning the mixer unit
The mixer unit must be cleaned on a daily basis as it
contains traces of milk products:
Disassembling the mixing unit:
! Pull the outlet tube for instant products out
completely both from the mixer housing and the
beverage outlet spout at the front.
" Turn powder chute for instant products to face
upwards and ...
# remove instant product container by lifting it
and pulling it forward. You can pull off and
remove the powder chute for cleaning.
GB
$ Loosen the mixer flange by turning its small
lever anti-clockwise.
% You can now remove the whole mixer housing
by pulling it forward and out of the machine.
Remove the mixer propeller by simply pulling it
➀
off its axle it only sits loosely on the axle.
$ You can now remove the loosened mixer flange.
Cleaning the mixing unit:
Now clean all parts thoroughly with hot water and
❍
a detergent suitable for milk products.
Rinse thoroughly in clean water and leave until
❍
completely dry.
Clean the uncovered end of the feed screw at the
❍
instant product container with a dry dusting
brush. This is the position where the powder
chute was removed.
Re-assembling the mixing unit:
Now re-assemble all parts in the reverse order.
Please note:
Replace mixer propeller with the marking
➀
(arrow) to the flattened side of the axle.
! The outlet tube for instant products must be
pushed completely onto the connection muffs of
the mixer unit and, at the front end, pushed
down fully into the beverage outlet spout.
"Re-assembling" continued on page 25
24
"
%
!
$
➀
$
➁
Publicité
Chapitres
Table des Matières
