Melitta cup-breakfast Mode D'emploi page 77

➇ ➈
Cleaning the area behind the air gap:
Before replacing the funnel on the mixing unit:
❍
❍
❍
Evacuating the coffee grounds drawer:
If the coffee grounds is not evacuated into a
container, but into the coffee grounds drawer:
➆
➉
❍
➆
Replace the instant container:
& Replace the instant product container in such a
&
➅
% Before closing the machine door, don´t forget to
➅
25
Pull out the sheet metal covering with the air
gap, lifting it up a little.
Thoroughly clean the area behind the sheet metal
covering and remove all instant residues.
Replace the sheet metal covering. Now you can
complete the re-assembly of the mixing unit by
replacing the funnel.
Empty the coffee grounds drawer whenever you
open the door. If this is not done and the drawer
is ...
– approx. 75% full, a warning symbol '
appears in the display.
– 100% full, no further brewing operations are
possible. A symbol ( appears in the display.
The coffee grounds drawer can be emptied into
the normal household rubbish. If the coffee
grounds drawer was removed for longer than 3 s,
the following messages appear after replacing
and closing the door ...
– the display asks if the coffee grounds
drawer is now empty. Confirm this by
pressing key 8 (enter).
– if the coffee grounds drawer was not
replaced after emptying, a warning
message ) appears in the display.
way that the pin at the front of the container
bottom ...
... clicks firmly into the hole on the bottom of
the instant product compartment. Only then is the
container correctly installed again.
turn the powder chute down into the funnel
again.
GB