Faults; Table; General - ETNA A361KZT Notice D'utilisation

Table

If the appliance does not work properly, this does not always mean that it is defective. Try to deal with
the problem yourself first by checking the points mentioned below:
Fault Probable cause
After the appliance has been electrified, text appears Normal operation.
in the displays.
After the appliance has been switched on, the fuse in Appliance incorrectly connected.
the meter cupboard blows.
The fan keeps on running after the appliance has The electronic circuits inside the hob are being
been switched off. cooled.
The hob does not work and the lights are not on. The appliance has been connected incorrectly
or the mains voltage is not right.
After the zone has been switched on, the displays The pan is not suitable for induction cooking or
the diameter is less than
shows the symbol .
12 cm.
While cooking, you hear a rattling noise in the base The noise is due to the high power of the
of the pan. cooking zone having an effect on the base of
the pan.
When you use the hob the first time, you notice that This is caused by the appliance's finish
it smells 'new'. heating up. It is perfectly normal.
A knob was operated too long or there is a
Failure code
break in the cable.
Failure code E4, E5, E6 of E9 Defect of generator.
Failure code E2 Appliance over heated.
Failure code E3
The pan is not suitable for induction cooking.
The childproof lock is switched on.
Failure code
Solution
NOTHING: see chapter "building in" in the
installation part of this manual.
Check the electrical installation.
This is normal.
Check the electrical installation (main fuse(s)
or the connection).
See chapter "Pans".
This is normal for some pans on higher
settings. It is harmless for the induction hob.
The odour will disappear of its own accord as
a result of ventilation.
Release the knob. Phone the service
organisation if the fault persists.
Contact the service department.
The appliance has been switched off because
of over heating. Let the appliance cool down
and start again on a lower setting.
See chapter "Pans".
See "Childproof lock", page 83.

General

In case of faults phone the service department.
See the guarantee certificate or consult the
internet site www.hps.nl.
If you notice a crack on the cooking
surface (no matter how little), switch
off the appliance immediately. Remove
the plug from the socket or set the switch of
the power supply cable (in the case of a fixed
connection) to zero or turn off the fuse switch(es)
in the meter cupboard.
Phone the service department.
This appliance should only be connected up by a
registered electrical installer!
The electrical connection must comply with
national and local regulations.
Damage caused by incorrect connection, incorrect
use or incorrect building in is not covered by the
guarantee.