Faults Table - ETNA A026VWRVS Notice D'utilisation

MAINTENANCE
Stubborn stains on enamel (pan supports, burner caps)
• Remove with a non-abrasive cream or a soft sponge. Never use
scouring powder, scouring pads, sharp objects or aggressive
cleansing agents.
Stubborn stains on stainless steel (drip trays)
• If spilled, acid fluids and sugary foodstuffs like red cabbage,
beetroot, soy sauce, applesauce and rhubarb may cause the surface
to discolour. Stubborn stains on stainless steel are best removed
with a special cleaning agent. Always polish in the direction of the
steel structure to avoid shine spots. (This kind of damage is not
covered by the warranty!)
• If the above methods do not remove the stains, clean the plate
with ATAG Shine. Remember to treat the entire drip tray in order
to avoid discolouring. Also, as a follow-up treat the drip tray with
a polish or maintenance agent for stainless steel. Please note that
over the years the surface will slightly discolour.
Cleaning removable burner components
• The removable burner components (including wok) are best
cleaned with a mild cleaning product and a soft cloth. In the case
of obstinate stains you can soak the parts in hot suds.
• Never use scouring powder, scouring pads, sharp objects or
aggressive cleansing agents.
Brass wok burner parts
• A few parts of the work burner are made from brass. It is normal
for the colour of the brass to change as a result of the high
temperatures that occur when cooking with a wok.
ATAG Shine
• Atag Nederland supplies a range of cleaning agents under the
name ATAG Shine. These can be obtained at the website at
www.atagservice.nl, where you will also find various cleaning and
operating tips.
GB 10
General FAULTS

Faults table

FAULTS
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first by
checking the points mentioned below in the table or visit our website
www.hps.nl for more information.
CAUSE SOLUTION
A burner is turned on but Close the tap and wait
not lit. for a few minutes before
relighting.
The coupling on a bottled Tighten the coupling.
gas unit has come undone.
Plug not in socket. Push the plug into the socket.
Fuse defective/fuse in meter Fit a new fuse or switch the
cabinet switched off. automatic fuse back on.
Sparkplug dirty/damp. Clean and dry the sparkplug.
Burner parts not correctly Assemble the burner parts
using the centring ridges.
installed.
Burner parts dirty/damp. Clean and dry the burner
parts, making sure that the
outflow holes are open.
Main gas tap closed. Open the main gas tap.
Fault in the gas network. Check with your gas supplier.
Control knob not kept Keep the control knob
pressed in long enough or pressed in far enough
far enough. between full and low.
GB 11
Faults table