General; Faults; Table - ETNA T200 Notice D'utilisation

General

Clean the cooking appliance after each use.
You can use a mild cleaning agent for this - for
example, washing-up liquid. Always clean the
hobs after use. You can use a mild cleaning
agent, such as washing-up liquid, for this
purpose. Special cleaning agents for ceramic
hobs have the advantage that a thin film
remains on the glass surface so that over-
cooked food and lime scale are less likely to
get burnt into the hob, making it easier to
clean the next time.
It is best to let the hob cool down before
cleaning it. Over-cooked food containing a lot
of sugar and acids, such as apple sauce,
rhubarb or red cabbage are best removed
immediately with a damp dish cloth to prevent
them getting burnt into the hob. Be careful
with the hot cooking zone!
You can use a glass-scraper to remove
obstinate food residue.
Traces of metals (due to sliding pans) can be
difficult to remove. Special products are
available for removing traces of metal.
Never use
You should never use scouring agents. These
cause scratches in which lime deposits and
dirt can accumulate.
Never use sharp objects such as steel wool
and scourers.
For cleaning tips refer to the internet site
'www.hps.nl'.

Table

If the appliance does not work properly, this
does not always mean that it is defective. Try
to deal with the problem yourself first.
Phone the service department if the advice
given below does not help. Only authorised
personnel may open the appliance or carry
out work on the mains power supply.
Fault Cause
Cooking zones do not get hot. – Appliance incorrectly
connected.
– Plug not, or not completely, in
the socket.
– Fuse(s) in the meter cupboard
defective.
Damage caused by incorrect connection,
incorrect installation or incorrect use is not
covered by the warranty.
In the case of faults visit the internet site
www.hps.nl.
Solution
– See the installation
instructions for correct
connection.
– Put the plug into the socket.
– Check the fuses in the meter
cupboard.