Disposal Of Packaging And Appliance; General; Electrical Connection - ETNA A361KZT Notice D'utilisation

Disposal of packaging and
appliance
The appliance packaging is recyclable.
The following may have been used:
cardboard;
n
polythene film (PE);
n
CFC-free polystyrene (PS hard foam).
n
Dispose of these materials responsibly and in
accordance with government regulations.
On the data plate is put the symbol of a
crossed-out wheeled dustbin:
This means that at the end of its working life, the
product must not be disposed of as urban waste.
It must be taken to a special local authority
differentiated waste collection centre or to a
dealer providing this service.
Disposing of a household appliance separately
avoids possible negative consequences for
the environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to obtain
significant savings in energy and resources.
As a reminder of the need to dispose of household
appliances separately, the product is marked with
a crossed-out wheeled dustbin.

General

This appliance meets all relevant CE guidelines.
The data plate on the underside of the appliance
indicates the total nominal load, the required
voltage and the frequency.
Safety
This appliance should only be connected up by
a registered electrical installer! The electrical
connection must comply with national and local
regulations.
The appliance should always be
earthed.
Damage caused by incorrect connection, incorrect
use or incorrect building in is not covered by the
guarantee.
For correct operation of the appliance it is
important that:
the power cable hangs freely and is not struck
n
by a drawer;
the worktop is level.
n
The walls and the worktop around the appliance
must be made of heatresistant (>85°C) material.
Even if the appliance itself does not get hot, the
heat from a hot frying pan, for instance, could
cause discolouring or damage to the wall or
worktop.

Electrical connection

For the connection, use an approved cable, in
accordance with the regulations. The cable casing
should be of rubber.
There is a label on the underside of the appliance
with the wiring diagrams. The connection
terminals are accessible once you have opened
the junction box on the underneath. The junction
box cover can be opened with a screwdriver.
If you want to make a fixed connection, make sure
that a multi-polar switch with a contact separation
of at least 3 mm is fitted in the supply line.