General; Faults; Table - ETNA T265 Notice D'utilisation

General

Clean the cooking appliance after each use.
You can use a mild cleaning agent for this - for
example, washing-up liquid. Always clean the
hobs after use. You can use a mild cleaning
agent, such as washing-up liquid, for this
purpose. Special cleaning agents for ceramic
hobs have the advantage that a thin film
remains on the glass surface so that over-
cooked food and lime scale are less likely to
get burnt into the hob, making it easier to
clean the next time.
It is best to let the hob cool down before
cleaning it. Over-cooked food containing a lot
of sugar and acids, such as apple sauce,
rhubarb or red cabbage are best removed
immediately with a damp dish cloth to prevent
them getting burnt into the hob. Be careful
with the hot cooking zone!
You can use a glass-scraper to remove
obstinate food residue.
Traces of metals (due to sliding pans) can be
difficult to remove.Special products are
available for removing traces of metal.
Never use
You should never use scouring agents. These
cause scratches in which lime deposits and
dirt can accumulate.
Never use sharp objects such as steel wool
and scourers.
For cleaning tips refer to the internet site
'www.hps.nl'.

Table

If the appliance does not work properly,
this does not always mean that it is
defective. Try to deal with the problem
yourself first.
Phone the service department if the
advice given below does not help. Only
authorised personnel may open the
appliance or carry out work on the mains
power supply.
Fault Cause
Cooking zones do not get hot. – Appliance incorrectly
connected.
– Plug not, or not completely, in
the socket.
– Fuse(s) in the meter cupboard
defective.
Error codes F00-F12 in the – A button is defective or dirty or
display. there is an object on top of it.
Each button has its own
number, from 00 to 12. The
number associated with the
button appears in the display.
Error code F3 appears. – Transistors overheated.
– The appliance has insufficient
ventilation.
Error code F99 appears. – Two or more buttons were
operated for a long time.
Spontaneous change of – Pan too close to buttons.
setting selected.
Damage caused by incorrect connection,
incorrect installation or incorrect use is
not covered by the warranty.
In the case of faults visit the internet site
www.hps.nl.
Solution
– See the installation
instructions for correct
connection.
– Put the plug into the socket
– Check the fuses in the meter
cupboard.
– Clean the appliance. Do not
place any objects on the
control panel.
– Allow the appliance to cool
down until the code
disappears.
– Make sure there is sufficient
ventilation.
– Do not operate more than one
button at the same time.
– Make sure that pan is at least
20 mm from buttons.