Faults; General; Troubleshooting Table - ETNA EKP358RVS Mode D'emploi

FAULTS

General

Troubleshooting table

Symptom
A slight smell is noticeable
the first few times the hob is
used.
You can hear a ticking sound
in your hob.
The hob is not working.
A fuse blows as soon as the
hob is switched on.
If you notice a crack in the glass top (however small), switch the hob
off immediately, unplug the hob, turn off the (automatic) fuse switch(es)
in the meter cupboard or, in the event of a permanent connection,
set the switch in the power supply lead to zero.) Contact the service
department.
If the appliance does not work properly, this does not always mean that
it is defective. Try to deal with the problem yourself first by checking
the points mentioned below.
Possible cause
The new appliance is heating
up.
This is caused by the
capacity limiter on the front
and back zones. Ticking can
also occur at lower settings.
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
Solution
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
Normal operation.
Check the fuses.
Check the electrical
connections.
EN 11