Faults; Table; General - ETNA T300 Notice D'utilisation

Table

If the appliance does not work properly, this does not always mean that it is defective. Try to
deal with the problem yourself first by checking the points mentioned below:
Fault Probable cause
After the appliance has been Normal operation.
electrified, text appears in the
displays.
After the appliance has been Appliance incorrectly connected.
switched on, the fuse in the meter
cupboard blows.
Only one side of the hob works or if Appliance incorrectly connected.
the appliance generates continuous
beep.
The hob does not work and the lights The appliance has been connected
are not on. incorrectly or the mains voltage is
not right.
The fan keeps on running after the The electronic circuits inside the
appliance has been switched off. hob are being cooled.
The appliance suddenly stops during The time programmed has expired,
use. You hear a double beep every something has boiled over or an
2 seconds and in the display a dash object is hindering the controls.
appears.
A series of dashes appear. Overheating of the electronics in the
hob.
The appliance does not work. In the Malfunctioning of the electronics.
display another message appears.
After the zone has been switched Unsuitable pans, pan smaller than 12
on, the zone displays continue to cm or no pan on the cooking zone.
flash.
While cooking, you hear a rattling The noise is due to the high power of
noise in the base of the pan. the cooking zone having an effect on
the base of the pan.
When you use the hob the first time, This is caused by the appliance's
you notice that it smells 'new'. finish heating up. It is perfectly
normal.
You hear a ticking sound in your hob. This is caused by the appliance
switching over from the rear cooking
zone to the front one and back again
or if you choose a low setting.
Solution
NOTHING: see chapter "building in"
in the installation part of this manual.
Check the electrical installation.
Check the electrical installation.
Check the electrical installation
(main fuse(s) or the connection).
This is normal.
Press the + or - button of the timer
and the beep will stop. Clean the
control panel or remove the object
and continue cooking.
Let the appliance cool down and
check the installation instructions
for correct installation.
Contact the service department.
See chapter
"Comfortable cooking".
This is normal for some pans on
higher settings. It is harmless for the
induction hob.
The odour will disappear of its own
accord as a result of ventilation.
This is normal.

General

In case of faults phone the service
department. See the guarantee certificate or
consult the internet site www.hps.nl.
If you notice a crack on the cooking
surface (no matter how little), switch
off the appliance immediately. Remove the
plug from the socket or set the switch of the
power supply cable (in the case of a fixed
connection) to zero or turn off the fuse
switch(es) in the meter cupboard.
Phone the service department.
This appliance should only be connected up
by a registered electrical installer!
The electrical connection must comply with
national and local regulations.
Damage caused by incorrect connection,
incorrect use or incorrect building in is not
covered by the guarantee.