Set Dial Mode; Pairing Further Pendants; Troubleshooting; If The Phone Does Not Work - HumanTechnik Scalla SOS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Press the »OK/DIAL« key. Use the -UP or -DOWN buttons to select 100ms, 270ms,
300ms, 600ms or 80ms. Set the desired flash time with the »OK/DIAL« key.

7.10. Set Dial Mode

The telephone dial mode is set to »TONE« by default. This setting does not need to be
changed under usual circumstances.
Enter the menu by pressing the »MENU« key and navigate to »SET DIAL MODE«.
Press the »OK/DIAL« key. Use the -UP or -DOWN buttons to select either "TONE"
or "PULSE". Set the selected dial mode by pressing the »OK/DIAL« key.

7.11. Pairing further pendants

You can pair up to 5 emergency pendants with the telephone. The included pendant
has already been paired to the telephone and is ready for use. If you wish to pair further
pendants, please proceed as follows:
Enter the menu by pressing the »MENU« key and navigate to »PAIR NEW PENDANT«.
Press the »OK/DIAL« key. The display will indicate »PAIRING«. Press the »OK/DIAL«
key again. »PAIRING« will flash on on the display, indicating the active pairing mode.
Within this time, press the red SOS button of the additional pendant.
If the pairing is successful, the display will show »DONE«.
Deleting paired emergency pendants
Enter the menu by pressing the »MENU« key and navigate to »PAIR NEW PENDANT«.
Press the »OK/DIAL« key. The display will indicate »PAIRING«. Use the -UP or
-DOWN buttons to select »DELETE?«. Press the »OK/DIAL« key to confirm. The
display indicates »DELETE DEVICE« and all paired pendants are deleted.

8. Troubleshooting

8.1. If the phone does not work:

Please ensure that the power supply is undamaged and is correctly plugged into the
phone and the electrical outlet. Use only the original power supply.
Please ensure that the phone cable is undamaged and is correctly plugged into the
phone and the phone line socket.
Remove possible existing accessories, extension cables and other phones. If the phone
works afterwards, then the fault was caused by a different device.
Connect a different phone to your phone connection. If this phone works, then your pho-
ne is probably defective. Please contact the retailer or the manufacturer.
Try to connect the phone at a neighbor's house. If the phone works there, then your
38 English

Publicité

Table des Matières
loading

Table des Matières