Warnings/Alarms - Arjohuntleigh Flowtron ACS900 Notice D'utilisation

Warnings/Alarms

To Change the Audible
Alarm Volume Setting
On detection of a fault condition, the pump provides a
visual-only warning followed by an audible and visual
alarm if the fault is not cleared.
1. The visual-only warning is a fault icon on the LCD
screen. The LED indicators remain unchanged and
there is no audible alarm.
2. If the fault is not cleared then the warning is
replaced by an audible and visual alarm, which
consists of:
• A fault icon on the LCD screen.
• The LED indicators on the front and underside of
the pump change to yellow.
• An audible alarm will sound.
The warning and alarm can be cleared by either:
• Rectifying the fault on the system, or
• Pressing the Middle Control button to put the pump
into Standby.
Refer to Section 7, Page 21 "Troubleshooting" for the
alarms, their possible causes and their remedies.
1. When the pump is in Standby, press the Left
Control button for 2 seconds to enter Audible
Alarm Volume Setting mode.
2. The Audible Alarm Volume and Audible Alarm
Status icons will be displayed in the bottom left of
the screen.
Audible Alarm
Volume
3. Each time the Middle Control button is pressed the
volume setting increases; if the volume setting is at
maximum, pressing the button again will cycle
back to the minimum setting.
4. The pump will save the selected volume setting
when the Left Control button is pressed.

If the Left Control button is not pressed for more
than 2 minutes, the selected setting will be stored,
the Volume and Audible icons will be removed and
the pump will exit the Audible Alarm Volume Setting
mode.
Minimum
Volume
17
Audible Alarm
Status
Medium
Volume
Maximum
Volume