Arjohuntleigh Flowtron ACS900 Notice D'utilisation page 42

Guidance and manufacturer's declaration - electromagnetic immunity
The pump is intended for use in the electromagnetic environment specified below. The customer or the
user of the pump should assure that it is used in such an environment.
Immunity Test
Electrostatic ±6 kV contact
discharge (ESD)
±8 kV air
IEC 61000-4-2
Electrical fast ±2 kV for power
transient/burst supply lines
IEC 61000-4-4 ±1 kV for input/
output lines
Surge ±1 kV line(s) to
line(s)
IEC 61000-4-5
±2 kV line(s) to
earth
Voltage dips, short <5% U
interruptions and
(>95% dip in U
voltage variations
for 0.5 cycle
on power supply
input lines
40% U
(60% dip in U
IEC 61000-4-11
for 5 cycles
70% U
(30% dip in U
for 25 cycles
<5% U
(>95% dip in U
5 sec
Power frequency 3 A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
Note: U is the a.c. mains voltage prior to the application of the test level.
T
IEC 60601 Test
Level
±6 kV
±8 kV
±2 kV
±1 kV
±1 kV
±2 kV
<5% U
T
) (>95% dip in U
T
for 0.5 cycle
40% U
T
) (60% dip in U
T
for 5 cycles
70% U
T
) (30% dip in U
T
for 25 cycles
<5% U
T
) for (>95% dip in U
T
for 5 sec
3 A/m
Compliance Electromagnetic environment -
Level
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be that of
a typical commercial or hospital
environment.
Mains power quality should be that of
a typical commercial or hospital
environment.
Mains power quality should be that of
T
a typical commercial or hospital
)
T
environment.
If the user of the pump requires
T
continued operation during power
)
T
mains interruptions, it is
recommended that the pump be
powered from an uninterruptible
T
power supply or a battery.
)
T
T
)
T
Power frequency magnetic fields
should be at levels characteristic of a
typical location in a typical
commercial or hospital environment.
32
guidance