Stopping Therapy; Switching Off The Pump - Arjohuntleigh Flowtron ACS900 Notice D'utilisation

Stopping Therapy

Switching Off
the Pump
6. Deflate the calf (or calf & thigh) garment.
7. This cycle of garment inflations repeats from step 1
until the therapy is stopped.
To stop the therapy and put the pump into Standby, press
and hold the Middle Control button for approximately 2
seconds until the Standby screen is displayed (refer to
"Standby Screens" on page 12) and then release it.
The LEDs on the front and underside of the pump are
extinguished.
If the pump stays in Standby, then:
1. After 5 minutes the LCD display backlight is
dimmed.
2. After a further 10 minutes (15 minutes total) the
pump automatically goes into an "Off" state:
• On mains power, the LCD screen backlight will
be extinguished and only the mains power and
battery indication icons will be displayed.
• On battery power, the pump will power down
and the screen will be blank.

The Mains indicator above the Power button will
remain green if the pump is connected to the mains
power and extinguished if the mains power is
disconnected.
To switch off the pump, press and hold the Power button
for approximately 2 seconds. Then,
• On mains power, the LCD screen backlight will be
extinguished and only the mains power and battery
indication icons will be displayed.
• On battery power, the pump will power down and the
screen will be blank.
1. Make sure the therapy is stopped and the pump is in
Standby (refer to "Stopping Therapy" on page 16).
2. If connected, disconnect the mains power.
3. Press and hold the Power button for approximately
2 seconds until the LCD screen goes blank.

The Mains indicator above the Power button will
remain green if the pump is connected to the mains
power and extinguished if the mains power is
disconnected.
16