Silk-n Infinity H3101 Mode D'emploi page 77

5.
Tip: Divide the area of skin you wish to treat into an – invisible – grid.
Begin in one "corner" and apply one light pulse after another working
sequentially across the grid.
The treatment surface is designed to leave behind slight pressure marks.
These visible marks will help you to position the device correctly for the
next light pulse.
6. Treat all remaining areas of skin as described in steps 3 to 5.
If you select the gliding method:
3. Using firm but gentle pressure, apply the device with the treatment surface
placed flat onto the area of skin to be treated. The indicator light "Skin type
warning"/"Light pulse ready"
4.
out galvanic micro current pulses and then continuous light pulses.
Position the device with the treatment surface on
an immediately adjacent area of skin. The indicator
light "Skin type warning"/"Light pulse ready"
slowly begins to flash again.
Avoid omissions or overlapping between the areas
of skin that are to be treated!
slowly begins to flash.
Press and hold down the pulse button continuously
(while touching the base electrode on the bottom
of the device) and pull the device slowly and care-
fully over the whole of the skin area to be treated.
The treatment surface must remain in contact with
your skin the whole time.
The skin type sensor first checks how light your skin
is. If it is in a suitable range, the device will first send
77 | en