Machine Charging - Numatic TRO 650G / 200T Notice Originale

!
Always ensure that the machine is switched off prior to charging.
33
34
35
36
The battery meter displays the charge level of the batteries; when fully charged, all meter
lights are illuminated (see Fig.33).
As the machine is used and the batteries are discharged, the meter lights will go out
from right to left.
If the battery-charge level is allowed to discharge to the point that only the red light
remains illuminated, the operator must consider charging the machine.
If the battery-charge level is allowed to discharge to the point that only one red light remains
illuminated (and begins to flash), all cleaning functions will automatically be disabled and the
operator should drive the machine straight to a suitable charge point.
The large capacity gel batteries are sealed for life and are totally maintenance free.
The on-board charger automatically monitors the charging process and will switch off
when the batteries are fully charged.
The machine charging point is located under the top tank. (see Fig.34).
Insert the charging lead required for your country into the charging point
and connect to a suitable power supply (see Fig.35).
Once the charging lead has been connected the red charging indicator will illuminate
(fig.36) and the display panel will show 'INHIBITED' and the battery level display lights will
flash in unison.
The machine will not operate.
To ensure a full charge, the machine should be left for a period of 8 hrs.
Once fully charged, disconnect the charging lead from both the power supply and the
machine.

Machine Charging

!
www.numatic.co.uk
28