Operating Instructions; General Preparation - SKF LAGG 18M Mode D'emploi

4. Operating instructions
4.1 General preparation
For all models
Contaminant will cause severe wear and
ultimately failure of the pump.
Prevent that the piston rod is (temporarily)
placed on a dirty surface at any time.
1. Remove the lid of the grease drum.
2. Place the follower plate on top of the
grease in the drum. Push the follower
plate down until the grease is
visible through the centre opening
of the plate.
3. Fit the cover plate on top of the drum.
4. Tighten the three butterfly screws to
secure the top to the drum. Ensure that
the cover plate is centred and securely
fixed to the drum.
5. Insert the piston rod of the pump
mechanism through the cover plate and
the follower plate. Ensure that the piston
rod penetrates all the way to the bottom
of the drum.
6. Secure the piston rod to the cover plate
by tightening the clamp-screw.
SKF LAGG
7