Procedure (Initial Installation Of The Unit) - Burkert MiniTOP 8633 Instructions De Service

3.2.2 Procedure (Initial installation of the unit)

Position display
(signal component)
See-through cover
Fig. 2: Installation of the MiniTOP
Preconditions: The valve with its drive, the correct accessory set (see data
sheet) and the MiniTOP must be available.
Screw off the see-through cover of the position display on the valve drive.
Inside the valve drive, screw off the orange/yellow signal component of the
position display using an Allen key.
Screw the switch spindle from the accessory set ( switch spindle with
brass guide piece) together with the plastic component on the piston rod of
the valve drive by hand, without fully tightening it at the moment.
30
MiniTOP
Type 8633
Brass guide
piece SW 27
Threaded pin
SW2
Upper cam
Lower cam
Switch spindle
Threaded part
O-ring
Valve drive
MiniTOP Type 8633