1
GENERAL INFORMATION
To ensure that the device functions correctly and will have a long service life,
please comply with the information in these operating instructions as well as
the operating conditions and the permissible ranges that are specified in the
data sheets of MiniTOP and the corresponding pneumatically operated valve:
•
When planning the application of the device, and during its operation,
observe the general technical rules!
•
Installation and maintenance work must only be carried out by specialist
staff using the correct tools!
•
Observe the relevant accident prevention and safety regulations applicable
for electrical equipment throughout the operation and maintenance of the
device!
•
Always switch off the electrical power supply before carrying out any work
on the system!
•
Take suitable measures to prevent unintentional operation or impermissible
impairment!
•
Following an interruption of the electrical or pneumatic supply, always
ensure a defined and controlled restart of the process!
•
If these instructions are ignored, no liability will be accepted from our side,
and the guarantee on the device and its accessories will also become
invalid!
1.1
Scope of delivery
Immediately after receiving the shipment, ensure that the contents are
undamaged and correspond to the scope of the delivery listed on the enclosed
packing note. In general, the delivery consists of:
•
the MiniTOP Typ 8633
alternatively:
•
a pneumatically operated process valve of the Type 2000, 2001, 2002,
2012, 2030, 2031, 2031K, 2652, 2655, 2658, 2672 or 2675,
The MiniTOP and the pneumatic valve drive already represent a
mechanical and functional unit
•
the operating instructions for the process valve with pneumatic drive
Operating Instructions No. 803 925
25