Turning The Minitop - Burkert MiniTOP 8633 Instructions De Service

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.3

Turning the MiniTOP

If the display LEDs of the MiniTOP Type 8633 are not easy to see after the
installation of the valve, or the connecting cable or the installation of the hoses
is difficult, the MiniTOP can be turned in relation to the pneumatic drive.
Proceed as follows:
First disconnect the unit from the electrical and pneumatic supplies!
Undo the fluid connections between the MiniTOP and the pneumatic drive.
Undo the threaded pins inset into the side of the housing using an SW 2
Allen key (see Fig. 2).
Turn the MiniTOP to the desired position without lifting.
Re-tighten the threaded pins with a moderate torque (0.2 - 0.4 Nm).
Refit the fluid connections between the MiniTOP and the pneumatic drive.
Use longer hoses where necessary.
Operating Instructions No. 803 925
33

Publicité

Table des Matières
loading

Table des Matières