User Interface Area; Installation; Charger Overall Dimensions - Cristec YPOWER Série Manuel Utilisateur

2.3 U
SER INTERFACE AREA
Programming
Input
fuse
3

INSTALLATION

This paragraph deals with installation of the equipment.
Installation and initial commissioning should be carried out by an electrician or professional installer in accordance
with the standards currently in force (for pleasure boats the applicable international standard is ISO13297).
The installer should familiarize himself with this operating manual and inform users of the instructions for use and the
safety warnings set out in the manual.
3.1 C
HARGER OVERALL DIMENSIONS
Place the charger vertically, connection downwards. Failure to respect this position may cause a decrease in available
power and a loss of IP level.
A clear area of 150mm all around the charger for proper ventilation and opening of the charger.
Never put anything on the charger.
buttons
Can BUS
Lin
On/Off
Temperature
sensor
Output
fuse
28