Cristec YPOWER Série Manuel Utilisateur page 25

Main precaution
Before handling the charger, please read carefully this
manual.
Precautions regarding electric shocks
Risk of electric shock and danger of death: it's strictly
forbidden to interfere with the charger when under
voltage.
Precautions regarding overheating of the appliance
This appliance is designed to be mounted on a vertical
wall or partition as indicated herein.
It is imperative that there be a gap of 150mm around
the charger. The installer must ensure that the
temperature of the air at the input is lower than 65°C
in extreme operating conditions.
Measures should also be taken to allow for the
evacuation of hot air on either side of the charger.
It's strictly forbidden to put any device on or against
the charger.
The charger must not be installed near a heat source;
it should be installed in a well-ventilated area. The
charger's air inlets and outlets must not be
obstructed.
Attention hot surface: do not touch the charger
during and after its operation (burn hazard).
24