User Interface Area; Installation; Charger Overall Dimensions; Wiring - Cristec CPS3 12V/16A Manuel D'utilisation

CPS3-1M-2M-DED
Access to the user interface area:

2.3. USER INTERFACE AREA

Refer to appendix 1 or 2 according to model.

3. INSTALLATION

This paragraph deals with installation-related arrangements.
Installation and initial commissioning should be carried out by an electrician or professional installer in
accordance with the standards currently in force (for pleasure boats the applicable international standard is
ISO13297).
The installer should familiarize himself with this operating manual and inform users of the instructions for use and
the safety warnings set out in the manual.
The charger is fixed by 4 M5 round screws (diameter of the screw < 10mm in order to allow the opening of the
cover).
Fixing distance: see the corresponding drawing in chapter charger charger overall dimensions.

3.1. CHARGER OVERALL DIMENSIONS

Refer to appendix 3,4 or 5 according to model.

3.2. WIRING

3.2.1. Cable lead-in

The mains cable lead-in is routed through a cable gland.
The battery cable lead-in is routed through cable bushings (possibility to mount cable glands in place; not supplied
: see paragraph accessories).
The accessory cable lead-in (see paragraph accessories) is routed through 3 slots located over the cable
bushings.
When connecting or disconnecting a cable, the charger's power supply must be off and the batteries electrically
insulated from the charger.
The references for additional supplies required for the appliance to operate efficiently are provided in the
following paragraphs: failure to comply with these provisions renders the warranty null and void.
19