User Interface Area; Programming Buttons; Temperature Sensor; Installation - Cristec YPOWER 12V-12V/60A Manuel Utilisateur

2.2
U
SER INTERFACE AREA
Programming
Input
fuses
3

INSTALLATION

This paragraph deals with installation of the equipment.
Installation and initial commissioning should be carried out by an electrician or professional installer in accordance with
the standards currently in force (for pleasure boats the applicable international standard is ISO13297).
The installer should familiarize himself with this operating manual and inform users of the instructions for use and the
safety warnings set out in the manual.
3.1
C /
HARGER CONVERTER OVERALL DIMENSIONS
Place the charger / converter vertically, connection downwards. Failure to respect this position may cause a decrease in
available power and a loss of IP level.
A clear area of 150mm is recommended all around the charger / converter for proper ventilation and opening of the
charger / converter.
Never put anything on the charger / converter.
Buttons
CAN-Bus
Lin
On/Off
Temperature
sensor
Output
fuses
33