Programming Field 4 : Offset On Boost Voltage; Programming Field 5 : Offset On Refresh Voltage - Cristec YPOWER Série Manuel Utilisateur

To exit the programming mode, go to programming field 4 and press the P key for 1 second.

3.3.5 Programming field 4 : offset on BOOST voltage

From the programming mode field 3, press for 1 second the button "P"
The ON led emits four successive flashes (see chaper 3.3.15.)
With the two + or - buttons, you can change the programming value
The internal programming can be read by counting the number of flashes on the green LED "FLOATING / REFRESH"
To exit the programming mode, go to programming field 5 and press the P key for 1 second.

3.3.6 Programming field 5 : offset on REFRESH voltage

From the programming mode field 4, press for 1 second the button "P"
The ON POWER led emits five successive flashes (see chaper 3.3.15.)
With the two + or - buttons, you can change the programming value
The internal programming can be read by counting the number of flashes on the green LED "FLOATING / REFRESH"
To exit the programming mode, press the P key for 1 second.
Setting CHARGER_Frame1
Can adress
0 0x0002 9000
1 0x0002 9001
0x0002 9002
2
3 0x0002 9003
0x0002 9004
4
5 0x0002 9005
0x0002 9006
6
7 0x0002 9007
Setting
Setting
8
9
10
11
12
13
14
15
Offset en mV
0 -400
1 -300
2 -200
3 -100
4
5 100
6 200
7 300
CHARGER_Frame1
Can adress
0x0002 9008
0x0002 9009
0x0002 900A
0x0002 900B
0x0002 900C
0x0002 900D
0x0002 900E
0x0002 900F
0
33