Safety Instructions - Altrad Belle BWE 150 Manuel De L'opérateur

GB
READ THESE SAFETY INSTRUCTIONS
Please read and understand all running/safety instructions before operating this machine.
BEFORE STARTING THE MIXER
• Check that all guards are in position and correctly
¿ tted.
• DO NOT wear loose clothing or jewellery that
may become entangled in the workings of this
machine.
• Suitable clothing as follows should meet relevant
EEC/local safety standards: overalls, work boots,
goggles, face mask, gloves and ear defenders
etc.
• On electric powered mixers, ensure that any
trailing cable is protected against damage and
not liable to be tripped over or trapped
underneath the mixer.
• Belle strongly recommends the use of a
Residual Current Device on 220/240v electrics.
• Remove all packaging material before operating.
WHEN OPERATING THE MIXER
• Keep unauthorised persons away from mixing
drum.
• Keep area around the mixer clear of obstructions
which could cause persons to fall onto moving
parts.
• Always ensure mixer is on level ground before
mixing.
• DO become familiar with the controls before
operating this machine.
• DO replace any worn/damaged warning decals.
• DO ensure the drum is rotating while emptying
the mixer.
• DO always switch off and remove the plug from
the socket if leaving the machine unattended.
• DO NOT transport this mixer when mixing.
• BEWARE of the danger zones.
EMERGENCY STOP
If you have to turn off the mixer in a emergency you must turn off at switch or at the mains.
FIRE FIGHTING
If your mixer catches ¿ re, turn off the electric supply. Using a dry powder or C0
If the ¿ re can not be put out, keep away and call the ¿ re brigade.
If you are in any doubt about the safety condition of your machine, please consult your nearest Belle dealer or Belle direct.

Safety Instructions

8
2
¿ re extinguisher put out the ¿ re.