Warning Decals; Maintenance Instructions - Altrad Belle BWE 150 Manuel De L'opérateur

WEAR EYE PROTECTION
WEAR EAR PROTECTION
Before starting any maintenance or repairs, switch off motor, and isolate from the main power supply.
On completion of maintenance, check that the mixer functions correctly and that all guards are correctly ¿ tted.
ELECTRIC MIXER
All portable electric appliances are dangerous if abused. This machine will only operate on one voltage. Check the power supply to
ensure it corresponds to the voltage as indicated on the rating label.
220/240v - Always use a Residual Current Device ("RCD"), (earth leakage trip), plugged directly into the 220/240v socket. If using an
extension cable, plug it directly into the RCD.
• DO NOT use an extension cable between the transformer and the power supply.
The symbols on the ON/OFF switch are 0=OFF and I=ON in accordance with international standards.
EXTENSION CABLES
If you need to use an extension cable it must be no longer than 30 metres (100 feet) in length. The wire section for 220/240v must
2 2
be 2.5mm and 6mm on 400v. Ensure that the extension cable is carefully laid out avoiding liquids, sharp edges and places where
vehicles might run over it. Unroll it fully or it will overheat and could catch ¿ re. Make sure that any extension cable connections are dry
and safe.
CLEANING
Wipe off any external material. DO NOT use petrol,
turpentine, lacquer or paint thinner, dry cleaning À uids or
similar products. Never let any liquids near the engine/motor.
Use 1" gravel and clean water to clean the inside of the drum.
DO NOT use bricks etc. as this will damage the drum.
DRIVE BELT
• DO NOT try to adjust with the motor running.
• DO NOT run slack.
• DO NOT operate machine with guards removed.
The drive belt is under constant tension, this requires no
attention. The bearings are sealed for life.

Warning Decals

FIRE AND EXPLOSIVE
RISK
WEAR PROTECTIVE
FOOTWEAR

Maintenance Instructions

9
READ OPERATOR
MANUAL
LIFTING POINT
GB
GB