Publicité
ASSEMBLY
l Push a hitch pin into the axle until the center of the pin rests
against the top of the axle.
l Repeat these steps to install second wheel.
CONNECTING THE BATTERY
See Figure 11.
A quick-connect battery cable is pre-installed on the battery.
Remove the cable tie securing the plugs then push firmly to
connect them.
NOTE: The generator is equipped with a battery charging feature.
Once the engine is running, a small charge will slowly recharge
the battery.
RAISING/LOWERING THE HANDLE
See Figure 12.
l Stand in front of the unit, grasp the handle firmly and lift it to
the raised position.
l With the handle in the raised position, the generator can safely
be rolled from one position to another. For information regarding
transporting the unit in a vehicle, refer to the Transporting
section in Operation.
l To lower the handle, gently guide the handle to the down position.
CAUTION
body part between the handle and the frame.
WARNING
unless instructed to so in this manual or by the manufac-
turer. Do not use attachments or accessories that are not
recommended for use with this product. Making unautho-
rized modifications and using incompatible accessories can
damage the unit and void the warranty.
OVERVIEW
This portable generator can provide power to a wide range of
items including household appliances, job-site tools, camping
equipment, tailgating essentials, and much more.
NOTICE
Do not attempt to crank or start engine be-
fore it has been properly serviced with recommended oil.
Failure to add engine oil before starting will result in serious
engine damage that is not covered under warranty.
Pinch point hazard. Do not place any
Do not alter or modify this product
FIG. 11
A
A - Quick-connect battery cable
FIG. 12
A
A - Handle
English | 17
Publicité
