Publicité
ELECTRICAL
GENERATOR CAPACITY
NOTICE
Do not overload the capacity. Exceeding the
wattage/amperage capacity can damage the generator and/
or electrical devices connected to it.
Review the Specifications for this generator and record the
running (continuous) and peak (starting) watts. In general the
higher the wattage, the more devices can be powered at the same
time. The total power requirements of all connected devices must
be considered. Power requirements are often listed on a data label
or nameplate.
To determine power requirements:
l Choose the devices to power simultaneously.
l Record and total the running (continuous) watts of each device.
The generator must continuously produce this amount of wattage
to keep the devices running.
l Record the peak (starting) watts for each device. This is the
momentary surge of power required to start electric motors in
some tools and appliances.
l Select the device with the highest peak (starting) wattage. Add
the peak (starting) watts for that device to the total running
(continuous) watts for all the connected devices to determine
the total peak wattage requirement for the generator.
NOTE: Total peak wattage requirement assumes intermittent
starting of devices. Adjust estimate if devices reach peak wattage
at the same time.
MANAGING GENERATOR POWER
To extend the service life of the generator, use caution when
adding electrical loads. Disconnect all loads before starting the
generator. The safest way to manage generator power is to add
loads sequentially by doing the following:
l Remove all loads and start the generator as described later in
this manual.
l Connect and start the largest device or appliance. Power re-
quirements are often listed on a data label or nameplate.
l Allow the generator output to stabilize. Once stable, the engine
should run smoothly and the device should function properly.
l Connect and start the next largest device or appliance.
l Allow the generator output to stabilize.
l Repeat this process for each additional load.
EXTENSION CORDS
WARNING
cords running directly into the home increase the risk of
carbon monoxide poisoning through any openings. If an ex-
tension cord running directly into the home is used to power
indoor items, there is a risk of carbon monoxide poisoning
to people inside the home. Always use battery-powered car-
bon monoxide detector(s) that meet current UL 2034 safety
standards when running the generator. Regularly inspect the
detector(s) battery.
WARNING
ing the generator with extension cords, be sure the genera-
tor is located in an open, outdoor area far away from occu-
pied spaces with exhaust pointed away.
WARNING
use worn or damaged extension cords. Damaged or over-
loaded extension cords could overheat, arc, and burn result-
ing in death or serious injury.
Before connecting an AC appliance or power cord to the generator:
l Use grounded 3-prong extension cords, tools, and appliances,
or double-insulated tools and appliances.
l Be sure the tool or appliance is in good working order. Faulty
appliances or power cords can create a potential for electric
shock.
l Be sure the electrical rating of the tool or appliance does not
exceed the rated power of the generator or the receptacle being
used.
NOTICE
Do not exceed the capacity. Overloading the
wattage and/or amperage capacity could damage connected
devices and critical generator components.
EXTENSION CORD SIZING
Be sure the extension cord can carry the required load. Cables
that are too small may cause a voltage drop that can cause the
cord to overheat or cause property damage. Refer to the cord
manufacturer's guidelines for the appropriate size and length.
Asphyxiation hazard. Extension
Asphyxiation hazard. When operat-
Fire and electrocution hazard. Never
English | 13
Publicité
