Publicité
EN
Before Use
1. Install Water Hookup Accessories for Auto Refilling
and Draining
After confirming the appropriate installation location, close the
main water valve or angle valve in your home and install the
water hookup accessories for auto refilling and draining in place.
Note: The completed installation is for reference only. Please refer to
the actual installation situation.
2. Place the Base Station and Connect to an Electrical Outlet
Remove any objects that are closer than 60 cm from the front
of the base station. Firmly insert the power cord until the
indicator turns on.
Within good Wi-Fi range
Note:
·
Make sure that no objects might block the signaling area.
·
To prevent water stains from wetting wood floors or carpets, placing
the base station on tile floors or marble floors is recommended.
13
3. Remove Robot Protections and Install Mop Assembly
②
①
I : ON
0: OFF
Before Use
4. Connect the Robot to the Base Station
Press and hold the button
turn it on. Place the robot onto the base station with the mop
assembly facing toward the washboard. Then you will hear a
voice notification when the robot successfully connects to the
base station.
After the robot is fully charged, the status indicators on the
robot and the base station will remain lit for 10 minutes and
③
then dim.
④
Note：It is recommended to fully charge the robot before its first use.
When the robot cannot be turned on after the battery is depleted,
manually connect the robot with the base station to charge it.
5. Test the Installation Effect
Use the Dreamehome App to test whether the base station can
successfully perform auto water refilling and draining.
Note: Before using the app, please make sure the robot has been
connected. For specific steps, please refer to the "Connecting with the
Dreamehome App" section.
6. Add the Cleaning Solution
(1) Remove the dust tank cover and pull out the auto-detergent
on the robot for 3 seconds to
compartment.
(2) Open the upper lid of the compartment and add the cleaning
solution.
(3) Close the lid of the compartment, put it back into the base
station, and then reinstall the dust tank cover. The cleaning
solution will be added automatically while working.
Note:
·
The auto-detergent compartment can be filled up with cleaning
solution for use. Do not add any liquid other than the officially-
approved cleaning solution to help prevent malfunction.
·
Install the auto-detergent compartment until it clicks into place.
EN
14
Publicité
