EN
Installation Instructions
Necessary Tools (not supplied)
Teflon Tape
Knife
21
Angle Valve
Monkey Wrench
Tape Measure
Installation Instructions
① Connect the Used Water Pipe
Floor Drain
3/8" Used
3/8" Elbow (thick)
Water Pipe
Note:
·
Before installing, please firmly press the snap ring on the elbow to remove the pre-installed anti-leakage cap.
·
It is recommended that the installation height of the used water pipe should not be higher than 80 cm.
② Connect the Clean Water Pipe
Water Source
1/4" Clean
Water Pipe
1/4" Elbow (thin)
EN
22