Publicité
EN
Installation Instructions
Installation Dimension
This product supports two installation methods: embedded in
cabinet or not embedded in cabinet.
Option ① Not Embedded in Cabinet
Remove any objects that are closer than 60 cm from the front
of the base station.
17
Option ② Embedded in Cabinet (with dust tank cover not visible)
width
depth
height
height
(above the ground)
How to install pipes
height
width
depth*
height (above the ground)
and wires
(mm)
(mm)
(mm)
(mm)
On the back side of
≥254
≥421
≥488
130
the base station
On either side of the
≥254
≥421
≥443
130
base station
*Depth data includes the cabinet door's thickness (approximately 20 mm).
Installation Instructions
Option ③ Embedded in the Cabinet (with dust tank cover visible)
width
depth
height
height
width
depth
How to install pipes and wires
(mm)
(mm)
(mm)
On the back side of the base station
≥254
≥421
≥468
On either side of the base station
≥254
≥421
≥423
Recommended Hole-cutting Size
Cabinet not installed yet
Cabinet installed already
If the cabinet is not installed yet:
Cut a square hole with a side length of 30 mm. This hole should
be reserved at the lower left/right corner of the cabinet side,
and the position is close to the ground.
If the cabinet has been installed already:
Cut a circular hole with a diameter of 30 mm. The distance
between the hole center and the ground shall not be higher
than 800 mm. The specific hole-cutting position shall be
determined according to the actual installation environment.
EN
18
Publicité
