Publicité
EN
How to Use
Turn On/Off
Press and hold the button
for 3 seconds to turn on the robot.
The power indicator will remain lit. Or, place the robot onto
the base station by aligning the charging contacts of the robot
with those of the base station, and then the robot will turn on
automatically and begin charging. To turn off the robot, move
the robot away from the base station and press and hold the
button
for 3 seconds.
Fast Mapping
After configuring the network for the first time, follow the
instructions in the app to quickly create a map. The robot will
start mapping without cleaning. When the robot returns to the
base station, the mapping process has been completed and
the map will be saved automatically.
Pause/Sleep
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically
enters sleep mode. All indicators on the robot will turn off.
Press any button on the robot, or use the app to wake up the
robot.
Note:If the robot is paused and placed onto the base station, the
current cleaning process will end.
27
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to
the base station to charge. After charging to the appropriate
battery level, it will resume unfinished cleaning tasks.
Note: To use this function, please enable it in the app.
Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the
robot will be prevented from resuming cleaning. The DND
mode is disabled by default at the factory. You can use the app
to enable the DND mode or modify the DND period. The DND
period is 22:00-8:00 by default.
Note:
·
The scheduled cleaning tasks will be performed as usual during the
DND period.
·
The robot will resume cleanup where it left off after the DND period
expires.
Robot Restarting
If the robot stops responding or cannot be turned off, press
and hold the button
for 10 seconds to forcefully turn it off.
Then, press and hold the button
for 3 seconds to turn the
robot on.
How to Use
Vacuum and Mop
Note:
·
When using the mop assembly for the first time, the robot performs
the "Vacuum and Mop" task by default.
·
During use, the base station will supply clean water and drain used
water automatically.
1. Start cleaning
Press the button
on the robot, or use the app to make the
robot start from the base station. Then the robot will plan the
optimal cleaning route and perform the cleaning task based
on the created map.
Note:
·
The mop pads will be cleaned before the robot starts mopping, please
wait patiently.
·
To ensure the robot easily returns to the base station after cleaning, it
is recommended to make the robot start from the base station. Do not
move the base station, the washboard or the washboard filter during
operation.
·
Hot water cleaning can be enabled in the app for mop pad washing
tasks, which applies to all modes. To prevent scalding, do not touch
the water outlet when the function is on.
2. Auto mop washing
When cleaning, the robot will automatically return to the
base station to wash mop pads based on the mop pad
cleaning frequency specified in the app. The base station will
automatically refill the robot's water tank and the robot will
resume cleanup.
3. Automatically empty the dust box and wash and dry
the mop pads
After the robot finishes a cleaning task and returns to the base
station to charge, the base station will automatically empty the
dust box and then wash and dry the mop pads.
Note:
·
If the auto-empty function is turned off in the app, the base station
will not automatically empty the dust box.
·
The base station will empty the dust box according to the setting in
the app.
EN
28
Publicité
