Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Instruction for work
5. Maintenance and periodical overhauls
5.1 Special sefety instructions
– Repair works, maintenance, periodical
overhauls, cleaning and elimination of
functional disturbances must be
performed with the switched off drive
and stand still engine! Remove the
ignition key!
– Do not use excessive quantities of oil
and grease. Be friendly to nature.
– When injured with splashed oil find
medical help immidiately.
– Consider other safety instructions to
prevent damages and accidents.
5.2 General
–
To insure faultless working of the
machine and to reduce the wear out
always consider the maintenance
instructions and periodical overhauls.
This includes cleaning, greasing and
lubricating of built in parts and
components.
Screws and nuts tightening moment M
(if not stated otherwise)
A = size of coil
A
8.8
Ø
M 5
5,9
M 6
10
M 8
25
49
M 10
M 12
85
M 14
135
M 16
210
M 20
425
M 24
730
M 27
1100
M 30
1450
A
10.9
12.9
M
(Nm)
A
8,7
10
15
18
36
43
72
84
125
145
200
235
310
365
610
710
1050
1220
1550
1800
2100
2450
After the first start and few hours of
working check the tightness of nuts
and screws, tighten them if needed.
Check up regulary (approx. every 50
hours)!
5.3 Tyres
– To mount tyres sufficient knowledge
and regulation tools are required.
– Repair works on tyres are allowed to be
performed by professionals with proper
tools only.
– Place the machine on flat and solid
ground. Secure it with wedges against
unintentional rolling off.
– Check the tyre pressure regularly.
Check the tyre pressure regularly and fill it up if
needed, Compare the measured values with the values
given in the table.
Type
SPIDER 400/4 ALP
5.4 Lubrication
In the figure all the lubrication spots are marked. Long
life of the swather is achieved if the time intervals
shown here are met.
5.5 Gear maintenance
Middle gaer must be filled with half liquid grease EP –
00.
20
Pressure
Tyre
(bar)
15 x 6,00 - 6
2
Publicité
Chapitres
Table des Matières
