Publicité
Cleaning
Clean the chain saw carefully after each application so that the
faultless function is kept.
Clean the case with a soft brush or a dry cloth.
Water, solvents and polishing agents shall not be
applied.
Check that the ventilation slots for the motor cooling
are free (risk of overheating).
If heavily contaminated, clean the device using a
commercial chain cleaner.
Remove all adhering substances with a brush from the
chain wheel (8) and guide bar retainers (A).
Clean the oil flow canal (G) with a clean cloth or a brush.
Pay attention during assembly that the seal (7) for
the oil flow channel has been inserted.
Cleaning of guide bar
Regularly inspect and clean
the oil discharge opening (H) of the guide rail, the chain
stretching pin (6) and the chain stretching screw (4)
Remove any burr using a flat file and emery paper.
Turn round the guide bar (1) after each chain
exchange/sharpening to avoid single-side wearing
Possible faults
Before each maintenance and cleaning work
switch off device
wait for stop of chain saw
pull out main plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Chain saw does not initiate
after switching on
Chain saw works with
interruptions
Chain saw picks, vibrates or
does not saw correctly
26
Possible cause
Chain brake
no power
Extension cable damaged
Main plug, motor or switch defect
external loose connection
internal loose connection
Circuit closer/breaker defect
Chain edgeless
Chain worn
Chain tension
Chain not assembled correctly
(teeth face to wrong direction)
Transport
Remove mains plug before each transport.
Transport the chain only with the chain protection put
on.
When transporting the product within a car put it in the boot or
on a separate loading area. Secure the chain saw against
tipping over.
Storage
Store machines that are not in use in a dry locked place
protected against frost and outside the reach of children and
unauthorized persons.
Before a longer period of storage carry out the following to
extend the power pruner
operation:
thoroughly clean the device
Remove the oil from the oil tank.
: Some chain oils tend to encrustations after a longer
period. For this reason the oil system should be flushed
before a longer storing with a chain saw cleaner. Fill the
cleaner up to the middle (appr. 50 ml) into the oil tank.
Close the tank. Switch on the chain saw without
assembled guide bar and chain until the complete cleaner
has left the oil opening of the chain saw.
Put the saw chain for a short time into an oil bath and
enwrap it afterwards in an oil paper.
Put the chain guard in place..
Removal
Release chain brake
Check power supply, power outlet, fuse protection
Check extension cable, exchange defect cable
immediately
Have motor or switch checked by an approved
electrician or replaced by original spare parts.
Check power supply, power outlet, fuse protection
Check extension cable, exchange defect cable
immediately
Please contact the after sales service
Please contact the after sales service
Chain must be regrinded or exchanged
Exchange chain
Check and adjust chain tension
Assemble chain again
s service life and ensure an easy
'
Publicité
